The dimming system shall have 6 circuits with a load capacity of 1200 Watts per circuit. Each circuit is protected by a 10 Amp fast acting circuit breaker. An allowance of 200% overhead capacity is employed in the circuit design. The dimming system shall have a rise time of not less then 350 microseconds. Setup attributes are via dipswitch controls. A user may program the dimmer attributes of DIM or RELAY, Stand Alone Chaser Mode setup, and unit address via the dipswitch controls. The dimming system shall use the USITT standard DMX-512 protocol or industry standard LMX-128 protocol for direct control of the dimming circuits.

Power requirements of the dimming system be 120/240 VAC Single Phase. Capacity shall be 30 Amps per leg. All connections for DMX control are made via 5 pin XLR connectors. Input electrical connections are made through a factory installed four conductor “pigtail,” the user supplies the connector. The dimming system is to mounted using standard lighting equipment clamps. Dimensions are 13.5” long, 8.5” wide, 3 3/8” deep; the weight shall be 9 pounds. The dimming system is covered by a 5 year factory warranty.