The 7750TG Test Signal Generator provides a cost-effective method of generating 270Mb/s serial digital test signals.The 7750TG is ideal for checking signal path integrity, monitor alignment or to determine system performance over varying cable lengths. The 7750TG generates a wide variety of industry standard test signals in 525 line and 625 line SMPTE ST 259-C video formats and offers four 270Mb/s outputs.Error detection and handling (EDH) codes are embedded on all the outputs to allow you to verify the performance of your digital signal paths.
525 line and 625 line formats
Card edge toggle switch selects test signal
On-screen display of test signal names
4 embedded audio tones, selectable audio group assignment
4 output drivers
On-screen text message can be used for source identification
On-screen setup menu
Card edge LEDs indicate genlock presence and module health
Signal Generator Type - Audio
Signal Generator Type - Video
Tester Format - Board/Card
Spec Sheet available - Yes
Input Signal Types:
Digital
Rack Units (Height):
1
Active Power:
6 Watt
DC Voltage:
12 Volts
Type:
NTSC or PAL Color Black 1V p-p
Composite Bi-level sync (525 Line or 625 Line) 300mV:
Connector:
1 BNC per IEC 61169-8 Annex A
Termination:
75 ohm (jumper selectable)
Standard:
SMPTE ST 259-C (270Mb/s)
Embedded Audio:
Up to 4 tones in one audio group as specified in SMPTE ST 272 Selectable tone frequencies (from 60Hz to 10kHz) and audio group Audio level is set to 20dB full scale