The 7700TPI VistaLINK® module links third-party equipment and Evertz VistaLINK® Network Management System (NMS). Third-party equipment with fault alarming capabilities via General Purpose Outputs (GPO), serial RS-232/422/485 connection, or Ethernet can communicate fault alarm conditions to the VistaLINK® application software through the 7700TPI to SNMP translator thereby extending fault monitoring capabilities across the broadcast network.The 7700TPI comes equipped with 4 RS-232/422/485 serial ports and 1 10/100 Mb Ethernet port. These ports can also be utilized to communicate and provide remote control to third-party equipment.
20 opto-isolated General Purpose Inputs (GPI)
Enabled GPI alerts translated and reported to Network Management System (NMS) user interface via SNMP
Selectable +5V or +12V supply for driving GPI over longer cable runs
8 relay closure General Purpose Outputs (GPO)
4 serial ports RS-232/422 selectable
GPI/GPO/Serial connections easily accessed through pin-headers (Phoenix Terminal Blocks) on rear plate
Modular, conveniently fits into 7800FR 3RU frame
Module status LED and simple GPI input diagnostics
Frame status trigger
VistaLINK® capable for remote monitoring and control via SNMP (using VistaLINK® PRO) when installed in 7800FR frame - Frame Controller built-in
Spec Sheet available - Yes
Active Power:
6 Watt
DC Voltage:
12 Volts
Number of Inputs:
20
Type:
Opto-isolated, active low with jumper selectable +5V or +12V supplied voltage
Connector:
Phoenix Terminal Block
Signal Level:
Jumper selectable +5V or +12V
Number of Outputs:
8
Number of Ports:
4 RS-232 or 3 RS-422
Baud Rate:
User selectable, up to 115200 bps
EMI/RFI:
Complies with FCC Part 15 Class A, EU EMC Directive