Permits users without T-coil equipped hearing aids to listen in induction loop equipped facilities. Contrary to popularly disseminated information, facilities which install induction loop assistive listening systems must still comply with applicable minimum supplied receiver requirements. The MI-2 readily meets these standards and is compatible with any stereo headphone equipped with a 3.5mm plug and any mono headphone equipped with a two pole mono or three pole "dummy" stereo(tip/ring +; sleeve -) 3.5mm plug. It is not compatible with mono devices wired with TRS plug (Tip +/Ring -/Sleeve NC).
Compatibile with Installed room loops, Countertoop loops, and Portable loop systems.
Light weight only 1.7 oz (47 g) with batteries
35+ hours on Two UM-4 (AAA) Batteries
Volume thumbwheel: ON/OFF
Slide action Power switch
Maximum load protection:
1.7 oz (47 g) with batteries
Material and Color:
ABS plastic, Grey ans Yellow
Battery Type:
Two UM-4 (AAA) Batteries
Operating Time:
35+ hours
Frequency Response:
150 - 6000 Hz +/- 3dB
Signal to Noise:
45 dB in 110 mA/m Magnetic Field
Controls:
Volume thumbwheel: ON/OFF
Output Level:
250 m Vrms (32 ohm load, magnetic field strength 100 mA/m)